Lantronix S3220 Series User Guide Rev J PDF 34.75 MB - Page 418

Transition Networks ION x222x / x32xx User Guide Cannot show circuit-ID on this card! You tried to display the Circuit ID information, but the function is not supported. 1. Make sure this is the command / function that you wanted. 2. Use the go command to switch to a device that supports Circuit ID display. 3. Try entering the command again. See "Circuit ID" on page 268. 4. If the problem persists, contact Technical Support. See Contact Us below. Cannot set circuit-ID on this card! You tried to display the Circuit ID information, but the function is not supported. 1. Verify the Circuit ID parameters. See "Circuit ID" on page 268. 2. Try entering the command again. 3. If the problem persists, contact Technical Support. See Contact Us below. Please reboot the card for the changes to take effect! You made a change that requires a system reboot in order for the change to take effect. For example: C1|S5|L1D>set snmp traphost svr 1 type ipv4 addr 192.168.1.30 Please reboot the card for the changes to take effect! C1|S5|L1D> 1. Reboot the card. See the "Reboot" section on page 292. 2. Continue the operation. 3. If a problem persists, contact Technical Support. See Contact Us below. Get DMI identifier no such object. You entered the CLI command to display DMI information, but it was not available. For example: C1|S3|L1P2>show dmi info Get DMI identifier no such object. C1|S3|L1P2> 1. Make sure this is the command / function that you wanted. 2. Try entering the command again. See "DMI (Diagnostic Maintenance Interface) Parameters" on page 395. 3. If a problem persists, contact Technical Support. See Contact Us below. 33472 Rev. J https://www.transition.com Page 418 of 700