Lantronix S3220 Series User Guide Rev J PDF 34.75 MB - Page 149

Transition Networks ION x222x / x32xx User Guide LOAM Config - Web Method 1. Access the NID through the Web interface (see "Starting the Web Interface" on page 45). 2. Select the port where LOAM is to operate. 3. Select the LOAM tab. Select the Main sub‐tab if not already selected. 4. In the Admin Status field, select Enabled. 5. In the LOAM Mode field, select the operating mode: • Active - the NID can initiate LOAM communications and can issue queries and commands to a peer device. When in Active mode, the NID sends out discovery frames (OAM Information PDU). In the Active mode, the NID can initiate LOAM Loopback to its remote peer. • Passive - the NID waits for the peer device to initiate LOAM communications and responds to, but does not initiate, commands and queries. When in Passive mode, the NID can receive and respond to discovery messages (OAM Information PDU). It cannot initiate LOAM Loopback, but can process loopback requests from a LOAM peer if that LOAM peer is in Active mode. Note: To perform Link Fault management, either the local client or the remote peer (or both) must have LOAM Mode set to Active (configured for Active mode operation). 6. Locate the Loopback Management section. 33472 Rev. J https://www.transition.com Page 149 of 700