Lantronix S3220 Series User Guide Rev J PDF 34.75 MB - Page 412

Transition Networks ION x222x / x32xx User Guide Set system name timeout. You entered a command to define system information, but the information on the card was not accepted. For example: C1|S10|L1D>set system name C3231 Set system name timeout. 1. Use the set system name command to enter the System Name information (e.g., set system name=NAME) without any special characters (e.g., without the ! or # or % or & characters). 2. Remove and reseat the card. 3. Try the operation again. 4. Select the MAIN tab > System Configuration section > System Name field, and verify the name and for the device. 5. If the problem persists, contact Technical Support. See Contact Us below. System is busy, please retry this command later! You entered a show or set command, but the command was not accepted by the system. For example: C1|S10|L1D>show https config System is busy, please retry this command later! C1|S10|L1D> 1. Wait 1-2 minutes and then retry the command. 2. Reboot the system and then retry the command. 3. If the problem persists, contact Technical Support. See Contact Us below. Get HTTPS state no such object. Get management VLAN state no such object. IP management state no such object. You entered a show or get command, but the command was not accepted by the system. For example: C1|S10|L1D>show https config HTTPS configuration Get HTTPS state no such object. C1|S10|L1D>show mgmt vlan config vlan id vlan state vlan portlist Get management VLAN state no such object. C1|S10|L1D>show ip-mgmt config IP management configuration IP management state no such object. 33472 Rev. J https://www.transition.com Page 412 of 700