Lantronix S3220 Series User Guide Rev J PDF 34.75 MB - Page 419

Transition Networks ION x222x / x32xx User Guide Get SNMP version no such object. You entered the CLI command to display SNMP configuration information, but it was not available. For example: C1|S3|L1D>show snmp config SNMP configuration Get SNMP version no such object. C1|S3|L1D> 1. Make sure this is the command / function that you wanted. 2. Verify the command syntax. See "Configuring SNMP" on page 245. 3. For complete command descriptions, see the ION System CLI Reference Manual, 33473. 4. Try entering the command again. See "DMI (Diagnostic Maintenance Interface) Parameters" on page 395. 5. If a problem persists, contact Technical Support. See Contact Us below. Fail to set Ethernet port loopback operation, please check if Link OAM admin state of remote peer port is enabled, link status and other issues. You entered the CLI command to define the type of Ethernet loopback test, but the command failed. For example: C1|S5|L1P2>set oam loopback oper init Fail to set Ethernet port loopback operation, please check if Link OAM admin state of remote peer port is enabled, link status and other issues. C1|S5|L1P2> 1. Make sure the Link OAM admin state of remote peer port is enabled (see "set oam admin state enable" command). 2. Verify the command syntax. 3. Use the set oam loopback ? command to display the card's loopback capabilities. For example: C1:S7:L1P1>set oam loopback type ? alternate noloopback remote 4. Re-enter the set oam loopback= command with a loopback capability supported by the card (alternate, or remote or noloopback). 5. Verify the loopback capability with the show oam loopback capability command. For example: C1|S5|L1P2>show oam loopback capability Loopback capability: alternate remotePeer C1|S5|L1P2> 6. If the problem persists, contact Technical Support. See Contact Us below. 33472 Rev. J https://www.transition.com Page 419 of 700