Lantronix S3220 Series User Guide Rev J PDF 34.75 MB - Page 187

Transition Networks ION x222x / x32xx User Guide The Trap Rate field is only valid if: • The policy selected is Trap. • A trap server (Trap Manager) is defined on the device's MAIN tab. • A trap server is on the network and available. d) Click Add. 7. Define additional rules as needed. 8. Define a condition for the Rule: a) Select a rule by clicking its index number. b) In the Type field, select the condition type. The options are Source MAC Address (1), IPv4 Address (2), IPv4 Address Range (3), IPv4 Network (4), TCP Port (5), TCP Port Range (6), UDP Port (7), UDP Port Range (8), or ICMP Type (9). c) In the Source or Destination field, select whether the type is a source or a destination. This is the restriction stream for source or destination. d) In the Operation field, select whether the match for this condition is equal to type or not equal to type. Select Equal or Not Equal. This is the operation between the Condition Type and Value. e) In the Value field, specify the MAC address, IP Address, Port number, or type associated with the selection in the Type field. There are 36 ICMP Type values selectable: 1. ICMP‐ECHO‐REPLY, 2. ICMP‐DESTINATION‐UNREACHABLE, 3. ICMP‐NETWORK‐UNREACHABLE, 4. ICMP‐HOST‐UNREACHABLE, 5. ICMP‐PROTOCOL‐UNREACHABLE, 6. ICMP‐PORT‐UNREACHABLE, 7. ICMP‐FRAGMENTATION‐NEEDED, 8. ICMP‐SOURCE‐ROUTE‐FAILED, 9. ICMP‐NETWORK‐UNKNOWN, 10. ICMP‐HOST‐UNKNOWN, 11. ICMP‐NETWORK‐PROHIBITED, 12. ICMP‐HOST‐PROHIBITED, 13. ICMP‐TOS‐NETWORK‐ UNREACHABLE, 14. ICMP‐TOS‐HOST‐UNREACHABLE, 15. ICMP‐COMMUNICATION‐PROHIBITED, 16. ICMP‐HOST‐PRECEDENCE‐VIOLATION, 17. ICMP‐PRECEDENCE‐CUTOFF, 18. ICMP‐SOURCE‐QUENCH, 19. ICMP‐REDIRECT, 20. ICMP‐NETWORK‐REDIRECT, 21. ICMP‐HOST‐REDIRECT, 22. ICMP‐TOS‐NETWORK‐REDIRECT, 23. ICMP‐TOS‐HOST‐REDIRECT, 24. ICMP‐ECHO‐REQUEST, 25. ICMP‐ROUTER‐ADVERTISEMENT, 26.ICMP‐ROUTER‐SOLICITATION, 27. ICMP‐TIME‐EXCEEDED, 28. ICMP‐TTL‐ZERO‐DURING‐TRANSIT, 29. ICMP‐TTL‐ZERO‐DURING‐REASSEMBLY, 30. ICMP‐PARAMETER‐PROBLEM, 31. ICMP‐IP‐HEADER‐BAD, 32. ICMP‐REQUIRED‐OPTION‐MISSING, 33. ICMP‐TIMESTAMP‐REQUEST, 34. ICMP‐TIMESTAMP‐REPLY, 35. ICMP‐ADDRESS‐MASK‐REQUEST, and 36. ICMP‐ADDRESS‐MASK‐REPLY. f) Click Add. 9. Define additional conditions as needed. 10. To change an existing Rule, select the Rule in the table, click the Edit button, and make changes per steps 5‐6 above. 11. Verify the newly‐defined Rules and Conditions. 33472 Rev. J https://www.transition.com Page 187 of 700