Epson SureLab D3000 Administrator Guide - Page 47
Measure Color, Create Calibration, from Calibration Creation
View all Epson SureLab D3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Settings/Maintenance Tip: O Nozzle Check is performed automatically before printing. If clogging is detected in the head, print again after cleaning the head and clearing the clogged nozzles. U "Head Cleaning" on page 27 O The number of charts printed varies depending on the settings and the paper. F The following screen is displayed after printing the first sheet. Follow the on-screen instructions, and then click OK. The charts the second sheet and after are printed. When the drying time reaches 0, Drying complete. is displayed, and the Measure Color button becomes available. H Check that the color measurement device you want to use is connected. I Click Measure Color from Calibration Creation Phase. Note: Do not allow the printed correction charts to overlap while drying. The color tone of the overlapped section may differ, leading to improper calibration. Tip: If the confirmation message is set not to display in Completion Confirmation for Long Length Sheet Printing from Printer Operation Settings, this message is not displayed. U "Printer Operation Settings" on page 23 G Wait for 30 minutes until drying is complete. Make sure the printed correction charts do not overlap during the drying process. Check the drying time displayed on Status. J Perform color measurement in the color measurement device in the same way as color measurement for the correction chart. U "Correction chart color measurement (for the "i1Pro")" on page 40 U "Correction chart color measurement (for the "i1iSis")" on page 42 K Click Create Calibration from Calibration Creation Phase. The calibration file is created. You can select the created calibration file in Calibration. 47