Epson SureLab D3000 Administrator Guide - Page 42
Correction chart color measurement (for the \, Measure Color
View all Epson SureLab D3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Settings/Maintenance Correction chart color measurement (for the "i1iSis") A Check that the color measurement device you want to use is connected. Tip: For more information on color measurement device, see the document supplied with the device. B Click Measure Color from Correction Value Creation Phase. Tip: O The color chart ID and preset ID are printed at the bottom of the correction chart. O If the paper width of the correction chart is wider than the maximum supported width of the color measurement device, cut off the margin along the cutoff line on the chart. D When color measurement is complete, click OK. C When the screen is displayed, check that the light on the right of the color measurement device is flashing green, and then insert the correction chart that matches the color chart ID and preset ID displayed on the screen into the color measurement device. Color measurement starts. Continue to create the correction value. U "Create, verify, and write the correction value" on page 43 42