Dell DSS 2500 Owners Manual - Page 97
Removing an expansion card on the internal PERC riser
View all Dell DSS 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Figure 43. Removing an expansion card on the internal PERC riser 1. expansion card guide slot on internal PERC riser 3. internal PERC riser 5. release tab 2. expansion card 4. PCIe connector on internal PERC riser card 6. locking notch on the expansion card Next steps 1. Follow the procedure listed in the After working inside your system section. 2. Install the internal PERC riser on the system board. 3. Install the cooling shroud. 4. If removed, reinstall the dual riser module. NOTE: If required, open the expansion card latch on the cooling shroud to support the full length card. 5. Reconnect the disconnected cables to the expansion card(s). Related references Safety instructions on page 53 Related tasks Before working inside your system on page 53 Removing the dual riser module (optional) on page 92 Removing the cooling shroud on page 59 Removing the internal PERC riser on page 94 Installing an expansion card into the internal PERC riser on page 98 Installing the internal PERC riser on page 95 Installing the cooling shroud on page 60 Installing the dual riser module (optional) on page 93 After working inside your system on page 54 Installing and removing system components 97