Dell DSS 2500 Owners Manual - Page 102
Installing a low profile expansion card into the dual riser module, Installing
View all Dell DSS 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
4. Remove the expansion card riser. 5. Unpack the expansion card and prepare it for installation. NOTE: For instructions, see the documentation that shipped with the expansion card. Steps 1. For expansion cards: a. To be installed in PCIe slots 3 and 4 of the dual riser module, lift the expansion card lock up. b. To be installed in PCIe slots 1 and 2 of the dual riser module pull, the expansion card lock down and away from the dual riser module. 2. Holding the card by its edges, position the card so that the card's edge connector aligns with the expansion card connector. 3. Insert the card's edge connector firmly into the expansion card connector until the card is fully seated. 4. Close the expansion card retention latch. Figure 48. Installing a low profile expansion card into the dual riser module a. low profile expansion card b. expansion card retention latch c. dual riser module Figure 49. Installing a low profile expansion card into the dual riser module 1. dual riser module 3. full height and full length expansion card 2. expansion card retention latch 4. PCIe slot on riser card 102 Installing and removing system components