Dell DSS 2500 Owners Manual - Page 93
Installing the dual riser module (optional
View all Dell DSS 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Installing the dual riser module (optional) Prerequisites CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product. 1. Follow the safety guidelines listed in the Safety instructions section. 2. Follow the procedure listed in the Before working inside your system section. 3. Install the expansion card on to the dual riser module, if applicable. NOTE: Ensure that the expansion card is properly seated along the chassis, so that the expansion card latch can be closed. Steps 1. Align the dual riser module with the guide pins on the chassis near PCIe slots 1 and 2. 2. Insert the dual riser module into the chassis and press the module to lock it into place. Figure 40. Installing the dual riser module 1. full height expansion card latch 3. expansion card riser (2) 2. dual riser module 4. PCIe connector on the system board (2) Next steps 1. If applicable, connect the cables to the expansion card(s). 2. Follow the procedure listed in the After working inside your system section. Related references Safety instructions on page 53 Related tasks Before working inside your system on page 53 Removing the dual riser module (optional) on page 92 Removing an expansion card from the dual riser module on page 99 After working inside your system on page 54 Installing and removing system components 93