Dell DSS 2500 Owners Manual - Page 41
Processor Settings details
View all Dell DSS 2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Processor Settings details About this task The Processor Settings screen details are explained as follows: Option Description Logical Processor Enables or disables the logical processors and displays the number of logical processors. If this option is set to Enabled, the BIOS displays all the logical processors. If this option is set to Disabled, the BIOS displays only one logical processor per core. This option is set to Enabled by default. Alternate RTID (Requestor Transaction ID) Setting Modifies Requestor Transaction IDs, which are QPI resources. This option is set to Disabled by default. NOTE: Enabling this option may negatively impact the overall system performance. Virtualization Technology Enables or disables the additional hardware capabilities provided for virtualization. This option is set to Enabled by default. Address Translation Service (ATS) Defines the Address Translation Cache (ATC) for devices to cache the DMA transactions. This option provides an interface between CPU and DMA Memory Management to a chipset's Address Translation and Protection Table to translate DMA addresses to host addresses. This option is set to Enabled by default. Adjacent Cache Line Prefetch Optimizes the system for applications that need high utilization of sequential memory access. This option is set to Enabled by default. You can disable this option for applications that need high utilization of random memory access. Hardware Prefetcher Enables or disables the hardware prefetcher. This option is set to Enabled by default. DCU Streamer Prefetcher Enables or disables the Data Cache Unit (DCU) streamer prefetcher. This option is set to Enabled by default. DCU IP Prefetcher Enables or disables the Data Cache Unit (DCU) IP prefetcher. This option is set to Enabled by default. Logical Processor Idling Enables you to improve the energy efficiency of a system. It uses the operating system core parking algorithm and parks some of the logical processors in the system which in turn allows the corresponding processor cores to transition into a lower power idle state. This option can only be enabled if the operating system supports it. It is set to Disabled by default. Configurable TDP Enables you to reconfigure the processor Thermal Design Power (TDP) levels during POST based on the power and thermal delivery capabilities of the system. TDP verifies the maximum heat the cooling system is needed to dissipate. This option is set to Nominal by default. NOTE: This option is only available on certain stock keeping units (SKUs) of the processors. X2Apic Mode Enables or disables the X2Apic mode. Number of Cores Controls the number of enabled cores in each processor. This option is set to All by default. per Processor Processor 64-bit Specifies if the processor(s) support 64-bit extensions. Support Processor Core Specifies the maximum core frequency of the processor. Speed Process Bus Speed Displays the bus speed of the processor. NOTE: The processor bus speed option displays only when both processors are installed. Processor 1 NOTE: Depending on the number of CPUs, there may be up to four processors listed. The following settings are displayed for each processor installed in the system: Pre-operating system management applications 41