2010 Polaris Vegas 8-Ball Owners Manual - Page 65

Engine Break-in Period Starting the Engine Operation CAUTION! Do not rev the engine or put the transmission in gear immediately after starting the engine. Allow the engine to idle for about one minute after a cold start, or 30 seconds after a warm start, to allow the oil to reach all areas requiring lubrication before the engine is put under load. 7. Leaving the throttle closed, press and hold the starter button to start the engine. Release the button promptly when the engine starts. If the engine does not start within 10 seconds, release the starter button. Wait five seconds, then try again. Tip: Hold the starter button for as short a time as possible to minimize battery drain. Do not hold the starter button for more than 10 seconds at one time. 8. If either the check engine indicator or the low oil pressure indicator does not go out after the engine starts, stop the engine. Refer to either the check engine indicator information on page 36 or the low oil pressure indicator information on page 37. Tilt Sensor The tilt sensor (if equipped) stops the engine if the motorcycle tips beyond 45 degrees to one side. If this occurs, the check engine light will also illuminate.To restart the engine, cycle the ignition switch to the OFF position, wait 10 seconds, then restart the engine. 63