2010 Polaris Hammer Owners Manual - Page 121

Headlight Aim Inspection Bullet Headlights: The top edge of the high beam must be 3 inches (7.6 cm) below the height of the headlight housing parting line and centered straight ahead at 25 feet (7.6 m). Round Headlights: The top edge of the low beam must be at the same height as the center of the headlight lens and centered straight ahead at 25 feet (7.6 m). 1. Verify that tire pressure is at specification. See page 108. 2. Verify that rear suspension ride height (preload) is at specification. Include rider, passenger (if applicable) and cargo when setting preload. See page 86. 3. Position the motorcycle on a level surface with the headlight 25 feet (7.6 m) from a wall. 4. With the operator and passenger (if applicable) on board, bring the motorcycle to the fully upright position. 5. Move the ignition switch to the ON position and switch the headlamp to high beam. Observe the headlight aim on the wall. 6. Make any necessary adjustments to headlight aim. Maintenance Bullet Headlight High Beam 25 ft. (7.6 m) 3 in. (7.6 cm) Height of headlamp housing parting line Round Headlight Low Beam 25 ft. (7.6 m) Height of center of headlamp lens 119