Panasonic WU-192ME2U9 Technical Data Manual - Page 350

9. Communication Adaptor (CZ-CFUNC1U) Control of 2WAY VRF SYSTEM 4 Setting the Communication Adaptor board The switches on the board control the adaptor numbers, turn the inter-unit control wiring connection on and off, and control other settings. D8 D7 D6 D5 D4 D3 7-segment LED S6 D1 S7 S8 S9 HOME D2 UP DOWN SET Home key Monitor LED Set key Down key 1 D1: red D2: green Up key (1) Switch operation overview Turn on the Power switch(S1) on the board.  Item selection Use the and keys to find the desired item, then press the key to select. 2 UP DOWN  Changing the settings SET Use the and keys to change the setting, then press the key to confirm. UP DOWN SET Hold down the key for at least two seconds to reset to the default setting lost.) HOME (Any settings in progress will be 3 (2) Adaptor number setting procedure  Hold down the key for at least two seconds so the initial display shows as follows: HOME (no.00) 4 After 2 seconds (AdP.dt) 5  Press the key five times so the following display appears: UP (no.05) This automatically switches to the below display after 2 more seconds. (Operation is not necessary.) 6 (FirSt)  Press the SET key so the below display appears. (Only the green monitor LED is on.) (1.Ano.00) (Factory setting) 7  Hold down the SET key for at least 1 second so the "00" part blinks, indicating that the setting can be changed. (The green and red monitor LEDs are both on.) Use the and keys to set the adaptor number. UP DOWN For example, to set number 3, press the key three times. The following will display: 8 UP 8 (1.Ano.03)  Press the SET key for at least 1 second to confirm. (Only the green monitor LED is on.) 9 3 - 278