Netgear XCM89UP Web Management User Guide - Page 246

M6100 Web Management User Guide • Static-Reject. Select Static-Reject to create a static-reject route for a destination prefix. No next hop address is specified in that case. 4. Enter the Next Hop IPv6 Address for the configured route. 5. Select from the Interface list, to specify in unit/slot/port format, the Link-Local IPv6 Next Hop Address. This field is enabled only if Link-Local is selected. 6. Specify the route Preference of the configured route. 7. Click Add to configure a new route. 8. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch 9. Click Delete to delete the corresponding route. IPv6 Route Table To display the IPv6 Route Table page, click Routing IPv6  Advanced  Route Table. The following page is displayed. 1. In the Routes Displayed field, select which routes to display from the following list: • All Routes-Show all active IPv6 routes. • Best Routes Only-Show only the best active routes. • Configured Routes Only-Show the routes configured by the user Table 93, IPv6 Advanced Route Table on page 246 describes the non-configurable data that is displayed. Click Update to update the page with the latest information on the switch. Table 93. IPv6 Advanced Route Table Field Number of Routes IPv6 Prefix Prefix Length Protocol Description Displays the total number of active routes in the route table. Displays the network prefix for the active route. Displays the prefix length for the active route. Displays the type of protocol for the active route. Routing 246