Netgear XCM89UP Web Management User Guide - Page 179

M6100 Web Management User Guide 6. Use Fast Leave Admin mode to select the Fast Leave mode for a particular interface from the menu. The default is disable. 7. Select the Proxy Querier Mode to Enable or Disable MLD Proxy Querier on the system. If it is disabled, then MLD Proxy query with source IP 0::0 is not sent in response to an MLD leave packet. If it is enabled, then MLD Proxy queries are sent. The default value is Enable. MLD VLAN Configuration To access the MLD VLAN Configuration page, click Switching Multicast  MLD Snooping  MLD VLAN Configuration. 1. Use VLAN ID to set the VLAN IDs for which MLD Snooping is enabled. 2. Use Admin Mode to enable MLD Snooping for the specified VLAN ID. 3. Use Fast Leave Admin Mode to enable or disable the MLD Snooping Fast Leave Mode for the specified VLAN ID. 4. Use Group Membership Interval to set the value for group membership interval of MLD Snooping for the specified VLAN ID. Valid range is (Maximum Response Time + 1) to 3600. 5. Use Maximum Response Time to set the value for maximum response time of MLD Snooping for the specified VLAN ID. Valid range is 1 to (Group Membership Interval - 1). Its value should be less than group membership interval value. 6. Use Multicast Router Expiry Time to set the value for multicast router expiry time of MLD Snooping for the specified VLAN ID. Valid range is 0 to 3600. Multicast Router Configuration To access the Multicast Router Configuration page, click Switching Multicast  MLD Snooping  Multicast Router Configuration. Configuring Switching Information 179