Netgear XCM89UP Web Management User Guide - Page 231

M6100 Web Management User Guide Note: When the configuration method is changed from DHCP to None there will be a minor delay before the page refreshes. 5. Use IP Address to enter the IP address for the interface. 6. Use Subnet Mask to enter the subnet mask for the interface. This is also referred to as the subnet/network mask, and defines the portion of the interface's IP address that is used to identify the attached network. 7. Use Routing Mode to enable or disable routing for an interface. The default value is enable. 8. Use Administrative Mode to enable/disable the Administrative Mode of the interface. The default value is enable. This mode is not supported for Logical VLAN Interfaces. 9. Use Forward Net Directed Broadcasts to select how network directed broadcast packets should be handled. If you select enable from the menu, network directed broadcasts will be forwarded. If you select disable they will be dropped. The default value is disable. 10. Use Encapsulation Type to select the link layer encapsulation type for packets transmitted from the specified interface from the menu. The possible values are Ethernet and SNAP. The default is Ethernet. 11. Use Proxy Arp to disable or enable proxy Arp for the specified interface from the menu. 12. Use Local Proxy Arp to disable or enable Local Proxy ARP for the specified interface from the menu. 13. Use Bandwidth (kbps) to specify the configured bandwidth on this interface. This parameter communicates the speed of the interface to higher level protocols. OSPF uses bandwidth to compute link cost. Valid range is (1 to 10000000). 14. Use ICMP Destination Unreachables to specify the Mode of Sending ICMP Destination Unreachables on this interface. If this is Disabled then this interface will not send ICMP Destination Unreachables. By default Destination Unreachables mode is enable. 15. Use ICMP Redirects to enable/disable ICMP Redirects Mode. The router sends an ICMP Redirect on an interface only if Redirects are enabled both globally and on the interface. By default ICMP Redirects Mode is enable. 16. Use IP MTU to specify the maximum size of IP packets sent on an interface. Valid range is 68 bytes to the link MTU. Default value is 0. A value of 0 indicates that the IP MTU is unconfigured. When the IP MTU is unconfigured the router uses the link MTU as the IP MTU. The IP MTU is the maximum frame size minus the length of the layer 2 header. 17. Click Apply to send the updated configuration to the switch. Configuration changes take effect immediately. 18. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 19. Click Delete to delete the IP Address from the selected interface. 20. Click Update to update the page with the latest information on the switch. Table 85, IP Interface Configuration describes the non-configurable data that is displayed. Routing 231