Epson ColorWorks C7500 Technical Reference Guide - Page 159
Setting the Dip Switches, Setting Procedure
View all Epson ColorWorks C7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Chapter 3 Handling Setting the Dip Switches Follow the steps below to change the Dip switch settings. Setting Procedure Follow the steps below to change the Dip switch settings. CAUTION Before you remove the DIP switch cover, turn the product off. Otherwise, a short-circuit may cause the product to malfunction. DIP switch settings are enabled only when the power is turned on. If the settings are changed after that, the functions will not change. 1 Make sure the power supply for the product is turned off. 2 Remove the Dip switch cover mounting screw from the rear side of the product and open the Dip switch cover. 3 Dip Switch Cover Dip Switch Dip Switch Cover mounting screw 3 Set the DIP switches, using the tip of a tool, such as a tweezers. 4 Replace the DIP switch cover, and screw it in place. Functions SW 1 2 3 4 ON OFF Power button: Disabled (Reset operation) Power button: Enabled (Power ON/OFF operation) Forbidden (Do not change setting) Reserved (Do not change setting) Reserved (Do not change setting) Initial setting OFF OFF OFF OFF CAUTION Do not change Dip switch 2 to 4. An SDHC memory card is located below the dip switches. Do not remove it, replace it or do any- thing else to it. This card is used for internal processing. 159