Netgear XCM89UP User Manual Software Version 11.x - Page 345

M6100, M5300, and M7100 Series Managed Switches 21. In the Adv Other Config Flag list, select Enable or Disable to specify the router advertisement other stateful configuration flag. Default value of other config flag is Disable. 22. In the Adv Suppress Flag list, select to Enable or Disable router advertisement suppression on an interface. The default value of the suppress flag is Disable. 23. In the Destination Unreachables list, select to Enable or Disable the mode of sending ICMPv6 destination unreachables on this interface. If disabled, then this interface does not send ICMPv6 eestination unreachables. By default, the IPv6 destination unreachables mode is enabled. 24. Click the Apply button. The updated configuration is sent to the switch. Configuration changes take effect immediately. The following table describes the nonconfigurable data that is displayed. Table 130. IPv6 Advanced Interface Configuration Field Operational Mode Link State Description Specifies the operational state of an interface. The default value is Disable. Indicates whether the link is up or down. IPv6 Prefix Configuration  Configure IPv6 prefix configuration: 1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for example, 169.254.100.201. 2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on the switch. 3. Launch a web browser. 4. Enter the IP address of the switch in the web browser address field. The default IP address of the switch is 169.254.100.100. The Login screen displays. 5. Enter the user name and password. The default admin user name is admin and the default admin password is blank, that is, do not enter a password. 6. Click the Login button. The web management interface menu displays. Routing 345