Netgear XCM89UP User Manual Software Version 11.x - Page 26

M6100, M5300, and M7100 Series Managed Switches The default admin user name is admin and the default admin password is blank, that is, do not enter a password. 6. Click the Login button. The web management interface menu displays. 7. Select System > Management > Initial Setup. The Initial Setup screen displays 8. Scroll down to display the Management VLAN Configuration section. 9. Specify the Management VLAN ID of the switch. The management VLAN is used for management of the switch. The VLAN ID can be any value from 1 to 4093. 10. Select the Routing Mode Enable or Disable radio button. The default is Enable. 11. Select the IPv4 Address Assignment DHCP or Static radio button. This specifies the method for getting IPv4 network parameters (IPv4 address and network mask) for the configured management VLAN interface. The default value for VLAN1 is Static. 12. In the IP Address field, specify the IP address of the management VLAN interface. The factory default value is 169.254.100.100. 13. In the Subnet Mask field, specify the IP subnet mask for the management VLAN interface. This is also referred to as the subnet/network mask and defines the portion of the interface's IP address that is used to identify the attached network. The factory default value is 255.255.0.0. 14. In the Gateway field, specify the default gateway for the management VLAN interface. The default value is 0.0.0.0. 15. Select an IPv6 Address Assignment radio button. This specifies the method for getting IPv6 network parameters (IPv6 prefix and prefix length) for the configured management VLAN interface. The possible options are DHCPv6, Auto Config, or Static. The default value for VLAN1 is Auto Config. 16. In the IPv6 Prefix and Prefix Length field, specify the prefix length for the management VLAN interface. Configure System Information 26