Netgear XCM89UP User Manual Software Version 11.x - Page 303

M6100, M5300, and M7100 Series Managed Switches 7. Select Switching > MLAG > Advanced > VPC Interface Configuration. 8. From the LAG Interface list, select the ID of the local port channel to configure as a VPC interface. 9. Enter a VPC interface identifier value in the VPC Identifier field. The possible range is 1 to 63. To form a VPC interface with a port channel on the peer device, the port channel on the peer device must use the same VPC identifier. 10. Click the Add button. The interface configuration is added. 11. To delete the selected interface configuration, click the Delete button. 12. Click the Apply button. The switch is updated with the values you entered. Configuration changes take effect immediately. The following table describes the nonconfigurable VPC Interface Configuration fields. Table 115. VPC Interface Configuration Field State Description The VPC interface's operational mode, which is one of the following: • Disabled. VPC functionality is operationally disabled on the VPC interface. • Wait. The port channel is waiting for VPC functionality to be enabled on a port channel on the peer device. • Error. VPC functionality is enabled on a port channel on both peer devices, but not all entry criteria are met for the port channel to be operational. For example, if the combined number of member ports for the VPC interface is more than the maximum allowed, then the state is set to Error on both devices. • Active. VPC functionality is enabled on a port channel on both peer devices, and all entry criteria are satisfied. The VPC interface is operationally enabled, and traffic is allowed to flow through the VPC member ports. • Inactive. The links connected to the VPC member ports are down, but the VPC interface on the peer remains active. Configure Switching Information 303