Netgear XCM89UP User Manual Software Version 11.x - Page 198

M6100, M5300, and M7100 Series Managed Switches 8. Reset Configuration - If you select this button and confirm your selection on the next screen, all VLAN configuration parameters are reset to their factory default values. Also, all VLANs, except for the default VLAN, are deleted. The factory default values are as follows: • All ports are assigned to the default VLAN of 1. • All ports are configured with a PVID of 1. • All ports are configured to an Acceptable Frame Types value of Admit All Frames. • All ports are configured with ingress filtering disabled. • All ports are configured to transmit only untagged frames. • GVRP is disabled on all ports and all dynamic entries are cleared. Configure an Internal VLAN The Internal VLAN section displays the allocation base and the allocation mode of internal VLAN. The internal VLAN is reserved by a port-based routing interface and invisible to the end user. Once these internal VLANs are allocated by the port-based routing interface, they cannot be assigned to a routing VLAN interface.  To configure an internal VLAN: 1. Prepare your computer with a static IP address in the 169.254.100.0 subnet, for example, 169.254.100.201. 2. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on the switch. 3. Launch a web browser. 4. Enter the IP address of the switch in the web browser address field. The default IP address of the switch is 169.254.100.100. Configure Switching Information 198