Netgear XCM89UP User Manual Software Version 11.x - Page 338

M6100, M5300, and M7100 Series Managed Switches 17. Use Encapsulation Type to select the link layer encapsulation type for packets transmitted from the specified interface. The possible values are Ethernet and SNAP. The default is Ethernet. 18. Use Proxy Arp to disable or enable proxy ARP for the specified interface. 19. Use Local Proxy Arp to disable or enable local proxy ARP for the specified interface. 20. Use Bandwidth (kbps) to specify the configured bandwidth on this interface. This parameter communicates the speed of the interface to higher level protocols. OSPF uses bandwidth to compute link cost. The valid range is 1 to 10000000. 21. Use ICMP Destination Unreachables to specify the mode of sending ICMP destination unreachables on this interface. If this is Disabled then this interface does not send ICMP destination unreachables. By default destination unreachables mode is enabled. 22. Use ICMP Redirects to enable or disable ICMP redirects mode. The router sends an ICMP redirect on an interface only if redirects are enabled both globally and on the interface. By default ICMP redirects mode is enabled. 23. Use IP MTU to specify the maximum size of IP packets sent on an interface. The valid range is 68 bytes to the link MTU. The default value is 0. A value of 0 indicates that the IP MTU is unconfigured. When the IP MTU is unconfigured, the router uses the link MTU as the IP MTU. The IP MTU is the maximum frame size minus the length of the Layer 2 header. 24. To delete the IP address from the selected interface, click the Delete button. 25. Click the Apply button. The updated configuration is sent to the switch. Configuration changes take effect immediately. To refresh the screen with the latest information on the switch, click the Update button. The following table describes the nonconfigurable data that is displayed. Table 127. IP Interface Configuration Field VLAN ID OSPF Admin Mode Link State Routing Interface Status Description The VLAN ID for the interface. Displays the OSPF admin mode of the interface. The default value is Disable. The state of the specified interface is either Active or Inactive. An interface is considered active if it the link is up and it is in forwarding state. Indicates whether the link status is up or down. Routing 338