LiftMaster HDSL24UL Installation Manual - English - Page 55

Wiring Diagram APPENDIX To protect against fire and electrocution: • DISCONNECT power (AC or solar and battery) BEFORE installing or servicing operator. CONTROL BOARD For continued protection against fire: • Replace ONLY with fuse of same type and rating. Jumper N.C. OPEN and COM: Hard Open (line-of-sight) CLOSE and COM: Hard Close (line-of-sight) STOP and COM: Hard Stop(line-of-sight) EXIT: Soft Open (used for exit probe, telephone entry, external exit loop detector, or any device that would command the gate to open) POWER LOCKS GATES PROTECTION LOOPS CONTROLS DUAL ENTRAPMENT ANTENNA EXIT LOOP SHADOW LOOP EDGE SENSOR for CLOSE cycle PHOTOELECTRIC SENSORS for CLOSE cycle MECHANICAL INTERLOCK NC PHOTOELECTRIC SENSORS or EDGE SENSOR for OPEN cycle Shielded Twisted Pair Cable (Primary/Secondary link to other gate operator) Ground the shield of the cable to the chassis ground of each operator. POWER SW - 24 VDC 1 A Maximum ACCESSORY ON POWER - 24 VDC 1 A Maximum ACCESSORY COM RESET SWITCH PRODUCT ID APS ENCODER MOTOR DRIVE 12V SOLAR PANELS IN SERIES ALARM EXPANSION BOARD SHADOW LOOP INTERRUPT LOOP PLUG-IN LOOP DETECTOR Model LOOPDETLM EXIT LOOP RELAY ADAPTER BOARD Jumper N.C. 3-BUTTON CONTROL STATION SINGLE BUTTON CONTROL STATION HD POWER BOARD Control function of Auxiliary Relays Control function of photoelectric sensor or edge sensor for the OPEN or CLOSE cycle. PHOTOELECTRIC SENSORS PHOTOELECTRIC SENSORS Red or EDGE SENSORS Black WIRELESS EDGE RECEIVER Attach ground wires to metal chassis with single PEM stud. Each ring term needs a separate nut. 55 EMI BOARD BLDC MOTOR 29-NP712 BATTERY SWITCH 12V BATTERIES IN SERIES INPUT POWER CONNECTION BRIDGE RECTIFIER AC POWER SWITCH TRANSFORMER