LiftMaster HDSL24UL Installation Manual - English - Page 51

ACCESSORIES Miscellaneous Post-mounting plate For post-mounting models CSL24UL, CSW24UL, CSW200UL, SL3000UL, HDSL24UL, and HDSW24UL commercial gate operators. Posts not included. Model MPEL Remote antenna extension kit The remote antenna extension kit allows the antenna to be remotely installed. Model 86LM Plug-in loop detector Low power. Conveniently plugs into existing control board. Not to be used as entrapment protection. Model LOOPDETLM Loop Detector Low power loop detectors mounted and wired separately inside control box. LiftMaster low power accessory. Not to be used as entrapment protection. Model LD7LP Vehicle sensing probe The vehicle sensing probe is buried in the ground and can detect a car as it approaches and will then open the gate. Model CP3 Solar panel kit This kit is to replace or add a solar panel to the operator application. 60W maximum for 24 Vdc operators and 30W maximum for 12 Vdc operators. Models SP10W12V (10 Watt, 12V) and SP20W12V (20 Watt, 12V) Magnetic gate lock Outdoor magnetic lock, transformer, junction box, mounting plate and hardware. Not for use with Solar Applications. Must be powered separately. Model MG1300 Heater The heater keeps the gearbox and batteries at a suitable temperature when the outside temperature is below -4°F (-20°C). The thermostat MUST be set between 45°F and 60°F (7°C and 15.5°C) to ensure proper gate operation. The heater can be powered by 110 to 250 Vac. Model HTR Solenoid lock harness kit Model K77-37972 Warning sign Model 40-39235 Long range RFID reader Model LMSC1000 LiftMaster® Internet Gateway Internet enabled accessory which connects your gate operator to your WiFi network and allows you to monitor and control gate operators and lighting accessories enabled by myQ® technology. Model 828LM myQ® Business™ connected access protocol - high capacity Models CAPXL and CAPXLV Transformer kit Changes input voltage (208/240/480/575 Vac) to an output voltage of 120 Vac. Rated 208/240/480/575 Vac, 5.2/4.5/2.3/1.9 A, 60 Hz, 1 PH Model 3PHCONV Transformer kit is NOT compatible with 33AH batteries. Batteries Gate access system batteries replace or upgrade the gate operator batteries. Two identical 12 Vdc batteries are required for each gate operator. Do not mix 7AH and 33AH batteries within a gate operator. 7AH batteries Standard 7 AMP-Hour Battery, 12 Vdc, to replace original batteries provided with operator. Reuse existing harnesses. Models 29-NP712 (1) and K74-30762 (2) 33AH batteries Upgrade 33 AMP-Hour Battery, 12 Vdc. Ideal for solar applications and extended battery backup. Two required. Model A12330SGLPK 33AH batteries are NOT compatible if transformer kit model 3PHCONV is installed. Battery harness, 33AH, HD Gates For 33AH battery applications. Model K41-0102-000 51