Invacare G5510 Owners Manual - Page 50

6 DEALER SECTION - PACKAGING, HANDLING, AND SET-UP 6.4 Assembling the Bed Ends Installing the Casters WARNING! Risk of Injury or Damage Ensure that all four casters are locked and that the bed does not move before transferring. - DO NOT transfer occupant to the bed if bed is not stable. 2. Insert the shaft of a locking caster assembly into the caster socket in the leg of one of the bed ends. 3. To prevent excess movement of the bed during assembly, lock the caster. Refer to Operating the Locking Function on the Locking Caster on page 38. 4. Repeat STEPS 1-3 for the remaining casters. Bed End Shaft Locking Caster Floor  For this procedure, refer to FIGURE 6 on page 49. 1. Lay the bed end flat on the floor. Caster Socket FIGURE 6 Assembling the Bed Ends Installing/Removing the Bed Ends Installing  For this procedure, refer to FIGURE 7 on page 50. 1. Stand one bed end as close to the head section as possible (Detail "A"). 2. Grasp the head section, by the side, and raise it until the rivets on the corner plates of the section are high enough to place into the corner locks on the bed end (Detail "A"). Part No 1180159-E 49 Invacare® G5510 Bed