Epson Runsense SF-810 User Manual - Page 21
GPS positioning, Indoor mode, Skipping GPS positioning
View all Epson Runsense SF-810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Setting up your SF-810 GPS positioning When you switch to the Measurement screen, the product receives a signal from various satellites, and identifies your GPS position. c Important: Make sure you are outside with no obstructions overhead, and try to keep the product as still as possible. Note: It usually takes less than two minutes to complete GPS positioning. If it takes more than two minutes and Failed is displayed, select Cancel, move to a different location, and try again. 1 Go to a location outside with no obstructions overhead. 2 Press C on the Time screen to perform GPS positioning. When the Measurement screen is displayed, you can start measuring. See "Measuring your workouts" on page 28. Skipping GPS positioning If you do not want to use GPS features, or if GPS positioning is taking too long, press C or D to highlight Skip, then press A. When GPS positioning is complete, the Measurement screen is displayed. The product continues to search for a GPS signal, and starts recording positional information when it successfully synchronizes with a satellite. The route you have travelled before the GPS has synchronized is not recorded, but distance and pace data can still be measured. The product will use the stride sensor until a GPS connection is made. See "Measurable items" on page 22. Indoor mode This function allows you to measure without performing GPS positioning. Your route is not recorded in Indoor mode. The measurements recorded by your product are also limited in Indoor mode. See "Measurable items" on page 22. 20