Kenwood TS-570D User Manual - Page 55
Beep Function, Display Dimmer, Program Function Button
View all Kenwood TS-570D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
BEEP FUNCTION The purpose of the Beep function is to provide an audible signal that conveys information. There are three types of signals: • To confirm that a button has been pressed. • To report an error condition; Morse codes are used for some errors. • To confirm that the selection was completed by pressing [MIC], [PWR], [KEY], [DELAY], or [FILTER] again. When selecting an operating mode, a Morse code abbreviation for that mode is heard. Mode Morse Code Output LSB USB CW CW -R FSK FSK -R AM FM (L) (U) (C) (CR) (R) (RR) (A) (F) You can change the volume of the beep output via Menu No. 01. DISPLAY DIMMER The Display illumination can be switched between 5 levels via Menu No. 00. PROGRAM FUNCTION BUTTON The transceiver allows you to customize the function of the front panel [PF] button. When using the optional MC-47 microphone, you can also customize the functions of the Mic [PF1], [PF2], [PF3], and [PF4] buttons. You can assign the following types of functions to these buttons via Menu No. 41 to 45: • Directly select Menu No. 00 to 40, 48 to 51. No need to press [MENU] and turn the MULTI/CH control. • Activate a function that is supported by no other front panel buttons. • Activate the same function as one of the front panel buttons. 12 OPERATOR CONVENIENCES Consult the following table to select a function. Selecting OFF assigns no function to the button. Function Number Function Function Number Function 00 to 40 Selects Menu 67 No. 00 to 40. See "MENU 68 CONFIGURATION". 69 [SCAN] [M>VFO] [M.IN] 50 Monitor 70 [CW TUNE] 51 Voice 1 71 [CH 1] 52 Voice 2 72 [CH 2] 53 DSP Filter Monitor 73 [CH 3] 74 [FINE] 60 QUICK MEMO [MR] 75 [F. LOCK] 76 [CLR] 61 QUICK MEMO [M.IN] Selects Menu No. 62 [SPLIT] 48 to 51. 80 to 83 Ex: 82 63 [TF-SET] selects 64 [A/B] Menu No. 65 [M/V] 50. 66 [A=B] 99 OFF 1 Press [MENU]. 2 Press [A/B] to select Menu A or Menu B. 3 Turn the MULTI/CH control to select Menu No. 41, 42, 43, 44, or 45. 4 Press [UP], [DOWN], Mic [UP], or Mic [DWN] to select a function number. • Consult the above table to select a function. 5 Press [MENU] to exit Menu mode. The default values are as follows: • Front panel [PF]: Voice 1 • Mic [PF1]: [A/B] • Mic [PF2]: [SPLIT] • Mic [PF3]: [M/V] • Mic [PF4]: Monitor Note: ◆ Full Reset returns the functions of the PF buttons to default settings. ◆ Function No. 84 accessible in step 4 is not currently available. Pressing the PF button with Function No. 84 assigned will simply cause the transceiver to display a string of error codes. 49