Kenwood TS-570D User Manual - Page 42
Rejecting Interference
View all Kenwood TS-570D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
REJECTING INTERFERENCE IF FILTER The IF filters are designed for selecting the exact range of intermediate frequencies that are sent to the next stage in the receive circuit. Interference adjacent to the desired signal can be reduced by selecting a narrow bandwidth filter and/or shifting the center frequency of the filter. To more effectively remove interference, use the IF filters with the DSP filters described on pages 37 and 38. CHANGING IF FILTER BANDWIDTH When adjacent frequency interference is present at both sides of the desired signal, a narrow IF filter bandwidth may be the best way to remove the interference. Changing the filter bandwidth will not effect the current receive frequency. To use a narrow filter in SSB, CW, or FSK mode, install the appropriate optional filter {page 58}, and select the appropriate setting in Menu No. 46. When in CW or FSK mode, the wide filter or the narrow filter is automatically selected, depending on the bandwidth of the DSP filter that you select. Refer to "CHANGING RECEIVE BANDWIDTH" {page 37}. The default in SSB or AM mode is wide bandwidth. In FM mode, you cannot change the filter bandwidth. Note: When you use Menu B, make sure to select the appropriate filter bandwidth via Menu No. 46 in Menu B. IF SHIFT For SSB, CW, or FSK mode, shifting the center frequency of the filter pass band is an additional method of fighting adjacent frequency interference. Shifting this center frequency does not change the current receive frequency. To remove interference that is higher in frequency than the desired signal, turn the IF SHIFT control counterclockwise. To remove interference that is lower in frequency than the desired signal, turn the IF SHIFT control clockwise. Desired Interfering signal signal NOISE BLANKER Noise Blanker was designed to reduce pulse noise such as that generated by automobile ignitions. Noise Blanker does not function in FM mode. Press [NB] to toggle Noise Blanker ON or OFF. • "NB" appears when the function is ON. Interfering signal Desired Interfering signal signal 1 Select SSB or AM mode. 2 Press [FILTER]. • The current filter selection appears. 3 Turn the MULTI/CH control to select Wide ("FIL-WID") or Narrow ("FIL-NAR"). 4 Press [FILTER] to complete the setting. 36