Kenwood TS-570D User Manual - Page 12

GETTING ACQUAINTED FRONT PANEL wq e ryt i u o !0 PF ATT PRE-AMP VOX PROC SEND AT TUNE HF TRANSCEIVER TS-570D PHONES MIC CH1 CH2 CH3 123 ANT REC FINE 456 NB AGC/TONE REV 789 F.LOCK CLR 0 ENT MIC LSB USB PWR CW FSK KEY FM AM DELAY MENU 1MHz !1 q (POWER) switch Press and hold down briefly to switch ON the transceiver power. Press again to switch OFF the power {page 13}. w PF button A function can be assigned by the user to this Programmable Function button {page 49}. The default function is Voice 1 {page 55}. e PRE-AMP button Press to switch ON or OFF the receive preamplifier {page 37}. r ATT button Press to switch ON or OFF the receive attenuator {page 37}. t PROC button Press to switch ON or OFF the Speech Processor for transmitting {page 32}. y VOX button In voice modes, press to switch ON or OFF the VoiceOperated Transmit function {page 31} or, in CW mode, to switch ON or OFF the Break-in function {page 34}. u AT TUNE button Use for activating the internal antenna tuner {page 52} or an external antenna tuner. i SEND button Press to switch the transceiver between receive mode and transmit mode {page 15}. 6 UP DOWN MR M.IN - SPLIT TF-SET A/B RIT M/V A=B CLEAR XIT SCAN M>VFO M.IN N.R. DSP SLOPE HIGH LOW LOW CUT B.C. CW TUNE FILTER RIT/XIT AF RF 4 6 + 2 0 CH IF SHIFT 4 8 10 SQL 6 2 0 8 10 o PHONES jack Connect headphones to this jack. Inserting a plug into the jack automatically mutes the audio from the speaker {page 3}. !0 MIC connector Connect a compatible microphone, then snugly screw down the connector locking ring {page 3}. !1 Multi-purpose keypad Consists of 10 buttons that are used for inputting numeric data. Also used for the following functions. • CH 1, CH 2, CH 3 buttons Press to select functions associated with the internal electronic keyer {page 34} and the DRU-3A Digital Recording Unit {page 53} . • ANT button Press to select either Antenna 1 or Antenna 2 that are connected to their respective antenna connectors on the rear panel {pages 1, 48}. • REC button Press to select the record mode for CW Message Memory {page 35} or for the optional DRU-3A Digital Recording Unit {page 53}. • FINE button Press to reduce by one-tenth the Tuning control step size to allow more precise tuning {page 29}. • NB button Press to switch ON or OFF the analog Noise Blanker {page 36}. • AGC/TONE button Press to switch the Automatic Gain Control function between Slow and Fast {page 30}. Also switches ON or OFF the Subtone {page 24} or CTCSS function {page 25}.