Kenwood TS-570D User Manual - Page 15
Microphone
View all Kenwood TS-570D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3 GETTING ACQUAINTED PF ATT PRE-AMP VOX PROC SEND AT TUNE HF TRANSCEIVER TS-570D PHONES MIC CH1 CH2 CH3 123 ANT REC FINE 456 NB AGC/TONE REV 789 F.LOCK CLR 0 ENT MIC LSB USB PWR CW FSK KEY FM AM DELAY MENU 1MHz @8 UP DOWN MR M.IN - SPLIT TF-SET A/B RIT M/V A=B CLEAR XIT SCAN M>VFO M.IN N.R. DSP SLOPE HIGH LOW LOW CUT B.C. CW TUNE FILTER RIT/XIT AF RF 4 6 + 2 0 CH IF SHIFT 4 8 10 SQL 6 2 0 8 10 @6 @7 @9 #0 #1 #2 #3 @6 DSP SLOPE (HIGH) control In SSB or AM mode, turn to change the high cut-off frequency of the receive pass band. Use the control to improve readability of the desired signal when higher frequency interference is present {page 37}. @7 DSP SLOPE (LOW) control In SSB or AM mode, turn to change the low cut-off frequency of the receive pass band. Use the control to improve readability of the desired signal when lower frequency interference is present {page 37}. @8 RIT/XIT control After switching ON the RIT or XIT function, turn to select the desired frequency offset {pages 30, 32}. @9 AF control Turn to adjust the audio frequency gain {page 13}. #0 RF control Turn to adjust the radio frequency gain {page 13}. #1 IF SHIFT control Turn to slide the receive pass band either lower or higher in frequency when interference is present {page 36}. #2 SQL control Used for muting ("squelching") the speaker output when no receive signal is present {page 14}. #3 MULTI/CH control In VFO mode, turn to step the operating frequency up or down {page 29}. In memory channel mode, turn to select a memory channel {page 40}. Also used for selecting Menu numbers when accessing the Menu mode {page 16}, and as a selector to choose settings for various functions activated by front panel buttons. MICROPHONE q UP/DWN buttons Use these buttons to step up or down the VFO frequency, memory channels, or Menu selections. Press and hold down to continuously change the settings. w PTT (Push-to-Talk) switch The transceiver is placed in transmit mode when this non-locking switch is held down. Releasing the switch returns the transceiver to receive mode. q DWN UP w PTT 9