Invacare XLT Owners Manual - Page 66

SECTION 9-OPTIONS Installing Gloves NOTE: For this procedure, refer to FIGURE 9.12 on page 66. 1. Wrap palm loop around horizontal handle (using top slot only) and secure to glove. 2. Run glove loop through bottom slot on palm and over back of hand until tight. Secure glove loop to back of glove. 3. Reattach glove strips to back of glove. Glove Glove Strip Palm Loop Secured to Glove Glove Loop Top Slot Palm Loop Glove Strip Horizontal Handle Bottom Slot FIGURE 9.12 Installing Gloves Mountain Drive Transmission Option ƽ WARNING DO NOT shift the mountain drive transmission option under load (i.e. using a high gear to start the handcycle in motion or to climb a hill, etc.). Shifting the mountain drive transmission option under load will damage the internal workings of the mountain drive option and will void the warranty. NOTE: For this procedure, refer to FIGURE 9.13 on page 66. Switching to Mountain Drive Transmission Option 1. Perform one of the following: • Switching Mountain Drive Transmission Option On ‐ Push in the gear shift button in the middle of the right side of the hand crank while the option is under no load. • Switching Mountain Drive Transmission Option Off ‐ Push the gear shift button on the left side of the hand crank in while the option is under no load. Hand Crank Gear Shift Button FIGURE 9.13 Mountain Drive Transmission Option Mountain Drive Transmission Option Maintenance The mountain drive transmission option should be maintained by a qualified technician according to the manufacturerʹs instructions included with the handcycle. Recumbent Handcycle Series 66 Part No 1114850