Invacare XLT Owners Manual - Page 50
Installing/Removing/Adjusting the Road Crown, Compensator
View all Invacare XLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
SECTION 8-SERVICE PROCEDURES Crank Arm Clamp Left Crank Arm Mounting Bolts and Locknuts Chain Ring Disk Right Crank Arm (Tabs) Spindle, Socket Screw and Cap Socket Screws Spindle, Socket Screw and Cap Crank Arm Clamp and Socket Screws FIGURE 8.2 Replacing the Crank Arms - XLT Gold, XLT PRO and Top End Force Installing/Removing/Adjusting the Road Crown Compensator NOTE: For this procedure, refer to FIGURE 8.3 on page 51. NOTE: The road crown compensator is designed to stabilize the handcycle during transfers and while riding and is not intended to keep the handcycle straight when pedaling but to keep the handcycle from leaning excessively to one side or another. Installing Road Crown Compensator 1. Position the bolt through the frame end of the road crown compensator. 2. Position the spacer on the bolt. 3. Install the bolt with spacer and road crown compensator into the mounting hole on the frame. 4. Rotate the fork to ensure the front wheel is pointing directly forward. 5. Position the fork end of the road crown compensator on the fork bolt. NOTE: If necessary, lengthen or shorten the road crown compensator to position the fork end onto the fork bolt. Refer to Adjusting Road Crown Compensator on page 51. 6. Secure the road crown compensator to the fork bolt with the locknut. Tighten securely. Recumbent Handcycle Series 50 Part No 1114850