Invacare JASMINE Owners Manual - Page 28

SECTION 8-ACCESSORIES Installing the Jasmine Scale NOTE: For this procedure, refer to FIGURE 8.2, Detail "A". ƽ WARNING The Jasmine Scale MUST be installed in the orientation shown in FIGURE 1. Otherwise, injury may occur. NOTE: If the scale is installed incorrectly, the swivel bar or cradle attachment will not rotate freely, limiting patient movement during transfer. 1. Align the holes in the top rubber cap, the holes in the Jasmine scale mounting bracket and the nylon spacers with the holes in the boom mounting bracket. Refer to Detail "A" for hardware orientation. 2. Attach the Jasmine scale to the boom mounting bracket with a screw, washer, bearings, flat washer and locknut. Refer to Detail "A" for hardware orientation. NOTE: Ensure the shaft of the screw passes through both sides of the boom mounting bracket. Installing the Swivel Bar or Cradle Attachment NOTE: For this procedure, refer to FIGURE 8.2, Detail "B". NOTE: The cradle attachment attaches in the same way that the swivel bar attaches to the Jasmine Scale. 1. Put the washers on the swivel bar pin. 2. Insert the swivel bar pin through the swivel bar. 3. Align the holes in the swivel bar pin with the hole in the bottom of the Jasmine scale mounting bracket. 4. Attach the swivel bar pin to the Jasmine scale with a screw and locknut. Tighten securely. 5. Snap a side rubber cap into place on each side of the boom mounting bracket. ƽ WARNING After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur. Top Rubber Cap Bearing Washer Screw Side Rubber Cap (2 total, 1 per side) DETAIL "A" INSTALLING THE SCALE Boom Mounting Bracket DETAIL "B" ATTACHING THE SWIVEL BAR Locknut Flat Washer Bearing Nylon Spacers Jasmine Scale Mounting Bracket Jasmine Scale Screw Washers Swivel Bar Pin FIGURE 8.2 Installing the Jasmine Scale Locknut Swivel Bar Jasmine™ Patient Lift 28 Part No 1150704