Dell Latitude 9510 Service Manual - Page 50

Installing the display assembly

Get Dell Latitude 9510 PDF manuals and user guides View all Dell Latitude 9510 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

Steps 1. Remove the single M1.6x3.5 screw securing the display-cable bracket, and remove the display-cable bracket . 2. Disconnect the display cable from the system board by pulling the pull tab in a direct upward motion, and disconnect and peel back the camera cable from the system board. NOTE: Technicians must disconnect the display cable from the system board by pulling the pull tab in a direct upward motion to prevent damage to the connector's pins. 3. Open the display assembly to 90-degree angle and flip over the system, and then place the system on a flat surface. 4. Remove the six M2.5x5 screws that secure the display assembly to the laptop, press the edges of the laptop near the hinges, and lift the hinges in the upward direction away from the laptop. 5. Lift the display assembly off the laptop. Installing the display assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. NOTE: The display assembly installation procedure is the same for both laptop and convertible chassis. About this task The following image indicates the location of the display assembly and provides a visual representation of the installation procedure. 50 Removing and Installing Components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
Steps
1.
Remove the single M1.6x3.5 screw securing the display-cable bracket, and remove the display-cable bracket .
2.
Disconnect the display cable from the system board by pulling the pull tab in a direct upward motion, and disconnect and peel back the
camera cable from the system board.
NOTE:
Technicians must disconnect the display cable from the system board by pulling the pull tab in a direct
upward motion to prevent damage to the connector's pins.
3.
Open the display assembly to 90-degree angle and flip over the system, and then place the system on a flat surface.
4.
Remove the six M2.5x5 screws that secure the display assembly to the laptop, press the edges of the laptop near the hinges, and lift
the hinges in the upward direction away from the laptop.
5.
Lift the display assembly off the laptop.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE:
The display assembly installation procedure is the same for both laptop and convertible chassis.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation procedure.
50
Removing and Installing Components