Dell Latitude 9510 Service Manual - Page 19

Installing the base cover

Get Dell Latitude 9510 PDF manuals and user guides View all Dell Latitude 9510 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Steps 1. Loosen the nine captive screws that secure the base cover to the system. 2. Using a plastic scribe, pry open the base cover starting from the recesses located in the U-shaped indents near the hinges at the top edge of the base cover. NOTE: Do not pull the base cover from the top side immediately after prying it from the recesses, as this will cause damage to the base cover. 3. Pry open the left and right sides of the base cover. 4. Pry open the bottom side of the base cover. 5. Hold the left and right sides of the base cover and remove it from the system. Installing the base cover Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task Removing and Installing Components 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
Steps
1.
Loosen the nine captive screws that secure the base cover to the system.
2.
Using a plastic scribe, pry open the base cover starting from the recesses located in the U-shaped indents near the hinges at the top
edge of the base cover.
NOTE:
Do not pull the base cover from the top side immediately after prying it from the recesses, as this will cause
damage to the base cover.
3.
Pry open the left and right sides of the base cover.
4.
Pry open the bottom side of the base cover.
5.
Hold the left and right sides of the base cover and remove it from the system.
Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Removing and Installing Components
19