Dell Latitude 9510 Service Manual - Page 37

Installing the 4-cell battery

Get Dell Latitude 9510 PDF manuals and user guides View all Dell Latitude 9510 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

Steps 1. Peel off the adhesive tape securing the wireless antenna cables in place and unroute the wireless antenna cables from the routing guides. NOTE: The cables for the wireless antennas are routed over the plastic bracket at the upper left corner and within the routing channels along the left and bottom side of the battery. Technicians must be careful when unrouting the antenna cables from their routing guides while they are still attached to the wireless card. 2. Remove the single (M1.6x3.5) screw and four (M2x3) screws that secures the battery. 3. Lift the battery from the left side of the system, and remove the battery from the laptop. Installing the 4-cell battery Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the battery and provides a visual representation of the installation procedure. Removing and Installing Components 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
Steps
1.
Peel off the adhesive tape securing the wireless antenna cables in place and unroute the wireless antenna cables from the routing
guides.
NOTE:
The cables for the wireless antennas are routed over the plastic bracket at the upper left corner and within
the routing channels along the left and bottom side of the battery. Technicians must be careful when unrouting the
antenna cables from their routing guides while they are still attached to the wireless card.
2.
Remove the single (M1.6x3.5) screw and four (M2x3) screws that secures the battery.
3.
Lift the battery from the left side of the system, and remove the battery from the laptop.
Installing the 4-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Removing and Installing Components
37