Paradigm PW Soundbar Manual - Page 10
If no stud is found, If a wall stud is found, If a wall stud is, found, Fig. 2b, Fig. 2a
View all Paradigm PW Soundbar manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
3. Using a stud finder, determine if there is a wall Fig. 2a stud directly behind one of the three center screw locations (fig. 2a). If no stud is found: use the center most screw location and drill a pilot hole for the wall anchor. Install a wall anchor or at this location. If a wall stud is found: drill a pilot hole into the stud. or 4. Using a screw, attach the wall bracket to the wall. DO NOT tighten (fig. 2b). 5. Using a stud finder, determine if a wall stud is directly behind any of the remaining screw locations (fig. 2a). If no stud is found: use the top and bottom center-most screw locations. If a wall stud is found: use the top and bottom screw locations with a stud behind them. Fig. 2b Use a level to square the wall bracket and mark the remaining pilot hole locations (fig. 2b). 6. Remove the wall bracket or pivot to access the remaining screw locations (fig. 2b). If no stud is found: drill pilot holes and install wall anchors. If a wall stud is found: drill pilot holes into the stud. 7. Using the screws, attach the wall bracket to the wall. DO NOT fully tighten. 8. Use a level to square the wall bracket. Tighten all screws (fig. 2b). 9. Attach audio and power cables as needed. Refer to the 'Connection' section of this manual. 10. Move the soundbar into place and drop the shoulder bolts into the wall bracket keyholes. Before releasing, make sure the soundbar has dropped fully into the keyholes and is held firmly in place (fig. 3). 9