Invacare M94 Owners Manual - Page 66

SECTION 10-SHROUD/WHEELS DETAIL "A" - TOP SHROUD Top Shroud DETAIL "B" - FRONT SHROUD Base Frame Hooks Rear of Wheelchair Base Frame Seat Supports Hook and Loop Strips Front of Wheelchair Release Knob FIGURE 10.1 Removing/Installing the Shrouds Front Shroud Engaging/Disengaging Motor Release Lever ƽ WARNING DO NOT engage or disengage the motor release lever until the On/Off switch on the joystick is in the Off position. CAUTION Ensure both motor release levers are fully engaged before driving the wheelchair NOTE: The motor lock disengagement/engagement allows freewheeling or joystick controlled operation. Freewheeling allows an attendant to maneuver the wheelchair without power. NOTE: For this procedure, refer to FIGURE 10.2 on page 67. 1. Locate the motor release handles on the motors protruding through the shrouds by the rear springs. 2. Perform one of the following: • To Disengage the motor release levers ‐ NOTE: This allows the chair to freewheel for pushing if necessary i. Slide the motor lock lever towards the outside of the wheelchair (free wheel position) as shown in Detail "A" of FIGURE 10.2. • To Engage the motor release levers ‐ NOTE: This allows the motors to drive the wheels. i. Slide the motor lock handles towards the center of the wheelchair (drive position) as shown in Detail "A" of FIGURE 10.2. Pronto® M94™ 66 Part No 1122145