Invacare M94 Owners Manual - Page 26

SECTION 4-SAFETY INSPECTION/TROUBLESHOOTING Information Gauge Display Diagnostics DISPLAY Information Gauge Display DESCRIPTION DEFINITION All LEDs are off. Power is off. COMMENTS All LEDs are on. Power is on. Fewer than three LEDs on implies reduced battery charge. Left RED LED is flashing. Battery charge is low. The batteries should be charged as soon as possible. Left to Right "chase" alter- Joystick is in program- The steady LEDs indicate nating with steady display. ming, inhibit and/or charg- the current state of the ing mode. battery charge. All LEDs are flashing slowly. Joystick has detected Out- Release the joystick back of-Neutral-at-Power-Up to Neutral. mode. Service Indicator Light Diagnostics NUMBER OF FLASHES 1 2 3 4 5 6 7 8 9 10 11 ERROR CODE DESCRIPTION POSSIBLE SOLUTION User Fault Battery Fault Left Motor Fault Right Motor Fault Left Park Brake Fault Right Park Brake Fault Remote Fault Controller Fault Communications Fault General Fault Incompatible or incorrect Remote Release joystick to neutral and try again. Charge the batteries. Refer to Charging Batteries on page 74. Check that battery cables are connected properly. Refer to Connecting/Disconnecting the Battery Wiring Harness on page 72. If necessary, replace batteries. Refer to Installing/Removing the Batteries on page 70. Contact Invacare/Dealer for service. Contact Invacare/Dealer for service. Contact Invacare/Dealer for service. Contact Invacare/Dealer for service. Check to make sure joystick is connected properly. Contact Invacare/Dealer for service. Contact Invacare/Dealer for service. Contact Invacare/Dealer for service. Contact Invacare/Dealer for service. Wrong type of remote connected. Contact Invacare/Dealer for service. Pronto® M94™ 26 Part No 1122145