Invacare M94 Owners Manual - Page 61
Replacing Heel Loops, Raising/Lowering Elevating Front Riggings, Adjusting/Replacing Telescoping
View all Invacare M94 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
SECTION 9-FRONT RIGGINGS 3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support. 4. Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest, if necessary. Replacing Heel Loops NOTE: For this procedure, refer to FIGURE 9.4. 1. Note the position of hex bolt, coved washers and locknut for reinstallation. 2. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support. 3. Remove the lower footrest. 4. Remove the phillips bolt, spacer and locknut that secure the existing heel loop to the lower footrest. 5. Slide the existing heel loop off the lower footrest. Locknut Coved Washer Footrest Support Lower Footrest Coved Washer Hex Bolt Phillips Bolt Spacer Heel Loop Locknut 6. Replace heel loop. 7. Reverse STEPS 1‐6 to reassemble. FIGURE 9.4 Replacing Heel Loops NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the spacer is secure. Raising/Lowering Elevating Front Riggings NOTE: For this procedure, refer to FIGURE 9.5. 1. Perform one of the following: • Raising ‐ Pull back on the release lever and raise front rigging to the desired height. • Lowering ‐ Support front rigging with one hand away from the release lever. Push release lever downward with other hand. Release Lever FIGURE 9.5 Raising/Lowering Elevating Front Riggings Adjusting/Replacing Telescoping Front Rigging Supports - Van Style Seats NOTE: When adjusting the telescoping front rigging support depth, ensure the footplate does not interfere with the caster wheel rotation. Part No 1122145 61 Pronto® M94™