Epson TM-T20II UB-R04 Technical Reference Guide - Page 36

Initializing the UB-R04

Get Epson TM-T20II PDF manuals and user guides View all Epson TM-T20II manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

Initializing the UB-R04 The UB-R04 setting can be reset to the default using the following method. The default setting is as follows. Communication standard: 802.11b/g/n Network mode: Infrastructure mode SSID: EpsonNet Encryption Type: WPA-PSK(AES) Passphrase: EpsonNet IP address: 192.168.192.168 Subnet mask: 255.255.255.0 * You can connect to a WPA2-PSK (AES) access point using the settings above. 1 Set the roll paper for the TM printer to print. 2 Turn off the TM printer. 3 While holding down the Push button, turn the TM printer on. Push the Push button using an extended paper clip or a pen point. 4 Wait for about 30 seconds without letting the Push button up. A receipt as shown below is printed. Do not turn the printer off until the initialization is completed. 36

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
36
Initializing the UB-R04
The UB-R04 setting can be reset to the default using the following method. The default setting is as follows.
Communication standard:
802.11b/g/n
Network mode:
Infrastructure mode
SSID:
EpsonNet
Encryption Type:
WPA-PSK(AES)
Passphrase:
EpsonNet
IP address:
192.168.192.168
Subnet mask:
255.255.255.0
*
You can connect to a WPA2-PSK (AES) access point using the settings above.
1
Set the roll paper for the TM printer to print.
2
Turn off the TM printer.
3
While holding down the Push button, turn the TM printer on.
Push the Push button using an extended paper clip or a pen point.
4
Wait for about 30 seconds without letting the Push button up. A receipt as shown
below is printed.
Do not turn the printer off until the initialization is completed.