D-Link DIS-200G Datasheet - Page 236
ingress-checking, Parameters, Default, Command Mode, Command Default Level, Usage Guideline, Example
View all D-Link DIS-200G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 236 highlights
DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide 43-2 ingress-checking This command is used to enable ingress checking for frames received by a port. Use the no command to disable the ingress check. ingress-checking no ingress-checking Parameters None. Default By default, this option is enabled. Command Mode Interface Configuration Mode. Command Default Level Level: 15. Usage Guideline Use this command to enable ingress checking for packets received by the interface. If ingress checking is enabled, the packet will be dropped if the received port is not a member port of the VLAN classified for the received packet. Example This example shows how to set ingress checking to enabled port eth1/0/2. Switch# configure terminal Switch(config)# interface Ethernet 1/0/2 Switch(config-if)# ingress-checking Switch(config-if)# 43-3 show vlan This command is used to display the parameters for all configured VLANs or one VLAN on the Switch. show vlan [VLAN-ID [, | -] | interface [INTERFACE-ID [, | -]]] Parameters VLAN-ID , - (Optional) Specifies a list of VLANs to display the member port information. If the VLAN is not specified, all VLANs are displayed. The valid range is from 1 to 4094. (Optional) Specifies a series of interfaces, or separate a range of interfaces from a previous range. No space before and after the comma. (Optional) Specifies a range of interfaces. No space before and after the hyphen. 232