Home » D-Link Manuals » Wireless » D-Link DIS-200G » Manual Viewer

D-Link DIS-200G Datasheet - Page 166

Simple Network Management Protocol(SNMP) Commands, show snmp-server, Parameters, Default

Add to My Manuals
Save this manual to your list of manuals

Page 166 highlights

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide 32. Simple Network Management Protocol(SNMP) Commands 32-1 show snmp-server This command is used to display the SNMP server's global state settings and trap related settings. show snmp-server [traps] Parameters traps (Optional) Specifies to display trap related settings. Default None. Command Mode EXEC Mode or Any Configuration Mode. Command Default Level Level: 1. Usage Guideline Use the show snmp-server command to display the SNMP server global state settings. Use the show snmpserver traps command to display trap related settings. Example This example shows how to display the SNMP server configuration. Switch# show snmp-server SNMP Server : Enabled Name : SiteA-Switch Location : HQ 15F Contact : MIS Department II Switch# This example shows how to display trap related settings. Switch# show snmp-server traps Global Trap State : Enabled Individual Trap State: Authentication : Enabled linkup : Enabled linkdown : Enabled coldstart : Enabled 162

Section	Page
1. Introduction	5
2. Basic CLI Commands	13
3. Access Management Commands	19
4. Asymmetric VLAN Commands	26
5. Basic IPv4 Commands	27
6. Basic IPv6 Commands	30
7. Cable Diagnostics Commands	32
8. Digital Diagnostics Monitoring (DDM) Commands	35
9. D-Link Discovery Protocol (DDP) ClientCommands	44
10. DoS Prevention Commands	47
11. Ethernet Ring Protection Switching (ERPS) Commands	50
12. File System Commands	63
13. Filter Database (FDB) Commands	65
14. GARP VLAN Registration Protocol (GVRP) Commands	73
15. IGMP Snooping Commands	80
16. Interface Commands	86
17. IP Utility Commands	94
18. Jumbo Frame Commands	95
19. Link Aggregation Control Protocol (LACP)Commands	96
20. Link Layer Discovery Protocol (LLDP)Commands	100
21. Loopback Detection (LBD) Commands	104
22. Mirror Commands	109
23. MLD Snooping Commands	112
24. Multiple Spanning Tree Protocol (MSTP) Commands	118
25. Power over Ethernet (PoE) Commands	123
26. Power Saving Commands	133
27. Port Security Commands	139
28. Quality of Service (QoS) Commands	144
29. RADIUS Server Commands	152
30. Remote Network MONitoring (RMON) Commands	156
31. Safeguard Engine Commands	164
32. Simple Network Management Protocol(SNMP) Commands	166
33. Spanning Tree Protocol (STP) Commands	184
34. Storm Control Commands	191
35. Surveillance VLAN Commands	194
36. Switch Port Commands	206
37. System File Management Commands	210
38. System Log Commands	218
39. Secure Shell(SSH) Commands	222
40. Time and SNTP Commands	223
41. Time Range Commands	229
42. Traffic Segmentation Commands	233
43. Virtual LAN (VLAN) Commands	235
44. Voice VLAN Commands	245
45. Web Authentication Commands	253
Appendix A - System Log Entries	258
Appendix B - Trap Entries	265