Marantz NA-11S1 Owner's Manual in English - Page 6

Cautions on handling, About the remote control, Inserting the batteries - replacement

Get Marantz NA-11S1 PDF manuals and user guides View all Marantz NA-11S1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Preparation Operation Cautions on handling About the remote control • Before turning the power switch on Check once again that all connections are correct and that there are no problems with the connection cables. • Power is supplied to some of the circuitry even when the unit is set to the standby mode. When going on vacation or leaving home for long periods of time, be sure to unplug the power cord from the power outlet. • About condensation If there is a major difference in temperature between the inside of the unit and its surroundings, condensation may form on parts inside the unit, causing it to fail to operate properly. If this happens, let the unit sit for an hour or two with the power turned off and wait until there is little difference in temperature before using the unit. • Cautions on using smart phones Using a smart phone near this unit may result in noise. If that occurs, move the smart phone away from the unit when it is in use. • Moving the unit Turn off the power and unplug the power cord from the power outlet. Next, disconnect the cables connected to other system units before moving the unit. Inserting the batteries q Remove the rear cover of the remote control. w Set two R03/AAA batteries in the battery compartment in the indicated direction. e Put the rear cover back on. NOTE • Insert the specified batteries in the remote control. • Replace the batteries with new ones if the set does not operate even when the remote control is operated close to the unit. (The supplied batteries are only for verifying operation. Replace them with new batteries at an early date.) • When inserting the batteries, be sure to do so in the proper direction, following the q and w marks in the battery compartment. • To prevent damage or leakage of battery fluid: • Do not use a new battery together with an old one. • Do not use two different types of batteries. • Do not attempt to charge dry batteries. • Do not short-circuit, disassemble, heat or dispose of batteries in flames. • Do not keep the battery in a place exposed to direct sunlight or in places with extremely high temperatures, such as near a heater. • If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries. • Remove the batteries from the remote control if it will not be in use for long periods. • Used batteries should be disposed of in accordance with the local regulations regarding battery disposal. • The remote control may function improperly if rechargeable batteries are used. Information 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
3
Cautions on handling
•
Before turning the power switch on
Check once again that all connections are correct and that
there are no problems with the connection cables.
•
Power is supplied to some of the circuitry even when the
unit is set to the standby mode. When going on vacation or
leaving home for long periods of time, be sure to unplug the
power cord from the power outlet.
•
About condensation
If there is a major difference in temperature between the
inside of the unit and its surroundings, condensation may
form on parts inside the unit, causing it to fail to operate
properly.
If this happens, let the unit sit for an hour or two with the
power turned off and wait until there is little difference in
temperature before using the unit.
•
Cautions on using smart phones
Using a smart phone near this unit may result in noise. If that
occurs, move the smart phone away from the unit when it
is in use.
•
Moving the unit
Turn off the power and unplug the power cord from the
power outlet. Next, disconnect the cables connected to
other system units before moving the unit.
Inserting the batteries
q
Remove the rear cover
of the remote control.
w
Set two R03/AAA batteries
in the battery compartment
in the indicated direction.
e
Put the rear cover back on.
About the remote control
NOTE
•
Insert the specified batteries in the remote control.
•
Replace the batteries with new ones if the set does not
operate even when the remote control is operated close
to the unit. (The supplied batteries are only for verifying
operation. Replace them with new batteries at an early date.)
•
When inserting the batteries, be sure to do so in the proper
direction, following the
q
and
w
marks in the battery
compartment.
•
To prevent damage or leakage of battery fluid:
•
Do not use a new battery together with an old one.
•
Do not use two different types of batteries.
•
Do not attempt to charge dry batteries.
•
Do not short-circuit, disassemble, heat or dispose of
batteries in flames.
•
Do not keep the battery in a place exposed to direct sunlight
or in places with extremely high temperatures, such as near
a heater.
•
If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
•
Remove the batteries from the remote control if it will not be
in use for long periods.
•
Used batteries should be disposed of in accordance with the
local regulations regarding battery disposal.
•
The remote control may function improperly if rechargeable
batteries are used.