Lantronix MatchPort b/g MatchPort b/g - User Guide - Page 43
Serial Port Access, Your choice, Enter, Save and exit
View all Lantronix MatchPort b/g manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
5: Configuration via Serial Mode or Telnet Port Figure 5-2. Change Setup Menu Options Change Setup: 0 Server 1 Channel 1 2 Channel 2 3 E-mail 4 WLAN 5 Expert 6 Security 7 Defaults 8 Exit without save 9 Save and exit Your choice ? 6. To select a menu option, enter the number of the option in the Your choice ? field and press Enter. View the current configuration by pressing Enter from the Change Setup menu. To enter a value for a parameter, type the value and press Enter. To confirm a current value, press Enter (without entering parameters). 7. When finished, save the new configurations (9 Save and exit). The unit reboots. Serial Port Access To configure the unit through a serial connection: 1. Connect a console terminal or PC running a terminal emulation program to serial port 1. The default serial port settings are 9600 baud, 8 bits, no parity, 1 stop bit, no flow control. 2. Reset the MatchPort unit by cycling the unit's power (turning the power off and back on). Immediately upon resetting the device, enter three lowercase x characters (xxx). Note: The easiest way to enter Setup Mode is to hold down the x key at the terminal (or emulation) while resetting the unit. You must do this within three seconds of resetting the MatchPort. Upon connection, the following information displays: Figure 5-3. MAC Address MAC address 00204A89E06A Software version V6.8.0.2 (120903) AES library version 1.8.2.1 Press Enter for Setup Mode 3. To enter the Setup Mode, press Enter within 5 seconds. Note: The connection fails if you do not press Enter within 5 seconds. MatchPort User Guide 43