Hoveround Teknique XHD User Manual - Page 39

Legrests

Get Hoveround Teknique XHD PDF manuals and user guides View all Hoveround Teknique XHD manuals
Add to My Manuals
Save this manual to your list of manuals

Page 39 highlights

Legrests 1. Install each legrest onto the appropriate hanger bracket and swing into the forward facing position. If your chair has elevating legrests, set the angle to the lowest position. 2. Fold down the foot plates. Your feet should comfortably rest on the plates without a tendency to lift your thighs from the seat cushion. 3. If length adjustment is necessary, loosen the bolt at the base of one of the legrest stems by two complete turns (1/2" wrench required). Tap the head of the bolt to loosen the inner tube from the outer tube (See Figure 6B below). 4. Slide the lower (inner) tube within the upper (outer) tube to achieve the correct legrest length. Tighten the bolt. 5. Repeat steps 3 and 4 for other legrest. Figure 6B - Legrest Adjustment D82007778 REV N 7/10/12 Chapter 6 39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
D82007778 REV N 7/10/12
Chapter 6
39
Legrests
1.
Install each legrest onto the appropriate hanger bracket and swing into the
forward facing position. If your chair has elevating legrests, set the angle to
the lowest position.
2.
Fold down the foot plates. Your feet should comfortably rest on the plates
without a tendency to lift your thighs from the seat cushion.
3.
If length adjustment is necessary, loosen the bolt at the base of one of the
legrest stems by two complete turns (1/2” wrench required). Tap the head of
the bolt to loosen the inner tube from the outer tube (See Figure 6B below).
4.
Slide the lower (inner) tube within the upper (outer) tube to achieve the
correct legrest length. Tighten the bolt.
5.
Repeat steps 3 and 4 for other legrest.
Figure 6B - Legrest Adjustment