Hoveround Teknique XHD User Manual - Page 32

Seat Back Angle Adjustment

Get Hoveround Teknique XHD PDF manuals and user guides View all Hoveround Teknique XHD manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Seat Back Angle Adjustment The seat back has fixed positions to select from (Figure 4I). To change the back angle position: 1. Locate the screw and nut on the left hinge and right hinge. 2. Remove the screw and nut and place the back in the desired angle position. Make sure the holes in the outer hinge and inner hinge brackets line up for the desired angle. 3. Re-install the screws and nuts into the new location and tighten securely. Figure 4I The seat back will fold forward when pushed from the rear or pulled from the front. Always use caution when pushing the chair from the back. If the chair must be pushed from the back, push or pull on the arms or another solid surface. 32 Chapter 4 D82007778 REV N 7/10/12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
32
Chapter 4
D82007778 REV N 7/10/12
The seat back will fold forward when pushed from the rear or
pulled from the front. Always use caution when pushing the
chair from the back. If the chair must be pushed from the back,
push or pull on the arms or another solid surface.
Seat Back Angle Adjustment
The seat back has fixed positions to select from (Figure 4I). To change the back angle
position:
1.
Locate the screw and nut on the left hinge and right hinge.
2.
Remove the screw and nut and place the back in the desired angle position.
Make sure the holes in the outer hinge and inner hinge brackets line up for
the desired angle.
3.
Re-install the screws and nuts into the new location and tighten securely.
Figure 4I