Adaptec 2906 User Guide - Page 18
running Macintosh OS 9, use the SCSI Card Control Panel to set, Installing Drivers - Windows - driver for
UPC - 760884150795
View all Adaptec 2906 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Connecting External SCSI Devices 6 If you are connecting external SCSI devices to a computer running Macintosh OS 9, use the SCSI Card Control Panel to set the maximum synchronous transfer rate to 5 MB/sec. Note: The DB-25 connector is not rated for speeds higher than 5 MB/sec. 7 Connect other external SCSI devices by cabling each device to the previous one, as shown. Only terminate the SCSI device at the end of the chain. Unterminated devices Terminated device 8 Replace the computer cabinet, and reconnect the power cord to the computer. Connect all power cables to the external SCSI devices. 9 Turn on all external SCSI devices and allow them to power up. Then turn on the computer. 10 Install the software driver for your operating system. See Installing Drivers - Windows on page 10 for detailed instructions. (If your computer is running Macintosh, you should already have installed the driver. See Installing Drivers - Macintosh on page 19.) 11 Install any software included with your SCSI device. 9