2010 Ducati Superbike 1198 R Corse Owners Manual - Page 40

Clock setting function This function is used to set the clock time. To set the clock, select the "TIME Set" page from the menu. Holding switch (1, fig. 10) pressed in position B "▼" for 3 seconds in this menu page gives access to the setup mode. On entering this mode, the message "AM" will flash; if you press switch (1, fig. 10) in position B "▼" the message "PM" flashes; if you press switch (1, fig. 10) in position B "▼" mode will go back to previous setting (if it is 00:00, when toggling from "AM" to "PM", 12:00 will be displayed). Pressing switch (1, fig. 10) in position A "▲" gives access to the hour setting mode; hours start to flash. Each time you press the button in position B "▼", the digit will increase by one hour. If the switch is held pressed in position B "▼" the number increases cyclically in steps of one hour every second (when the switch is held depressed, the hours do not flash). Pressing switch (1, fig. 10) in position A "▲" gives access to the minute setting mode; minutes start to flash. Each time you press the button in position B "▼", the digit will increase by one minute. If you hold the switch down in position B "▼", the count increases cyclically in steps of 1 minute every second. If the button is held depressed in position B "▼" for over 5 seconds, minutes will increase by 1 minute every 100ms (while the button is held depressed in position B "▼", seconds will not flash). Pressing the button in position A "▲", exits setup mode and the new time is displayed. E B 3secs. sec. B= = ON ON per for 3 Lampeggiante Flashing B Lampeggiante Flashing B A A B Lampeggiante Flashing B Lampeggiante Flashing A A Lampeggiante Flashing B B A Lampeggiante Flashing A fig. 28 39